How to Create Screw and Snap-Fit Latches?
After receiving their vacuum-formed enclosures, many clients' first question is: "Where do we fasten the screws? How do we incorporate snap-fit latches?"
This is a very practical question. A vacuum-formed part is essentially just a "shell"; unlike injection-molded parts, it does not come with pre-existing screw bosses or latch structures built directly into the mold design. However, this is not a problem; there are established methods to resolve it.
This article clearly explains how to create assembly structures on thick-gauge vacuum-formed parts.
1. Why don't vacuum-formed parts come with built-in screw?
Vacuum forming involves heating a plastic sheet and drawing it onto a mold via suction to form a shape. This process dictates that the wall thickness of the vacuum-formed part remains essentially uniform throughout; unlike injection molding, it is not possible to locally accumulate material to create raised features such as screw bosses.
Therefore, assembly structures on vacuum-formed parts are typically implemented through post-processing or by embedding inserts. It is not that it cannot be done-the method simply differs.
Method 1: Bonded Screw Bosses (Most Common)

Procedure: A small screw boss is separately injection-molded or machined, then bonded to the inner wall of the vacuum-formed part using adhesive.
Advantages:
Simple and low-cost.
Flexible positioning-can be placed wherever desired.
Suitable for prototyping and small-batch production.
Disadvantages:
The adhesive requires time to cure.
Structural strength depends on the adhesive used and the bonding surface area.
Not suitable for high-temperature environments.
Applicable Scenarios: Small to medium-batch production, standard strength requirements, room-temperature environments.
Adhesive Selection: Use acrylic or epoxy adhesives for ABS materials; use specialized PC adhesives for PC materials.
Method 2: Heat-Melted Screw Bosses (Recommended)

Procedure: A pre-molded screw boss is heated using thermal bonding equipment and pressed into a pre-drilled pilot hole in the vacuum-formed part; as the plastic melts, it fuses directly with the screw boss. Advantages:
Significantly more secure than adhesive bonding
No curing time required
Suitable for mass production
Disadvantages:
Requires hot-melt equipment (low capital investment)
Pilot holes for screw bosses must be pre-drilled
Applicable Scenarios: Mass production; products requiring reliable connections
Method 3: Embedded Inserts (High-Strength Requirements)
Procedure: Prior to vacuum forming, metal or plastic inserts are placed at designated locations within the mold; during the forming process, the plastic material encapsulates the inserts.
Advantages:
Highest structural strength
Inserts and housing form a single integrated unit
Ideal for areas subject to high mechanical stress
Disadvantages:
Complex mold design
Strict requirements for insert positioning accuracy
Higher cost
Applicable Scenarios: High-strength applications; large-scale mass production
How are Snap-Fit Features Created?
Snap-fit features are used to rapidly assemble two components without the need for screws. When creating snap-fits on vacuum-formed parts, the underlying principle is similar to that of screw bosses-typically, they are created either through post-processing or by incorporating "half-snap" features directly into the mold design.

We will recommend the most suitable assembly solution based on the product's intended application, frequency of disassembly/reassembly, and anticipated mechanical loads. If technical drawings are available, we can provide a detailed, specific evaluation.
